AmQuake Forums — Mesh generation

Re: Mesh generation

null@example.com (jcervenka) — Tue, 28 Jun 2011 12:35:58 +0000

Hello, when the check box (Ceilings without bending stiffness) in on, no connection, i.e. no stiffness in bending is considered.

When the check box is off, the displacements and rotations of each node of the ceiling are connected through special constraint conditions. These conditions guarantee that all nodes in the ceiling deform as a one entity. I.e. they can rotate but their relative distance is always prevailed, see chapter 6.2.2 in the AmQuake manual.

With best regards

Jan Cervenka

Re: Mesh generation

null@example.com (concordia2) — Mon, 27 Jun 2011 20:48:07 +0000

but how is the stiffness in the node calculated?

Re: Mesh generation

null@example.com (support) — Mon, 27 Jun 2011 13:39:55 +0000

Check (Without bending stiffness) = without stiffness (stiffness only in RCRing)
Uncheck (Without bending stiffness) = infinitely stiffness in ceiling

Mesh generation

null@example.com (concordia2) — Sun, 26 Jun 2011 16:17:51 +0000

When the option "Ceilings without bending stiffness" is inactive i.e. when the program takes the bending stiffness i account, how is the stiffness calculated and taken in the calculation for different nodes?